All our BMW e-brake handles are machined out of aluminum for perfect fitment. Available in a round design for all past BMW vehicles and a square base design for all newer BMWs.

Our silver e-brake handles are brushed, and our titanium handbrakes are anodized with a matte finish. Our chromed e-brake handle has a fully chromed body over finely machined aluminum. Our Black handles are powder coated to resist scratching and wear. Our AutoCarbon carbon fiber e-brake handles are made from real silver or black carbon fiber layered over machined aluminum. New to our line-up is the beryllium aluminum handbrakes, which gives a look found nowhere else.

The 3 bolts, instructions, the allen key and zip tie are all provided with each e-brake handle. No permanent modifications are necessary to your vehicle to make the installation of this product possible. Make sure you check out our other BMW interior products to go along with your e-brake handle.

NOTE: These e-brake handles replace only the handle itself. Your original e-brake button will remain in place.

NOTE: For E90, E92, E60, E63, E65, E70, E71 models: If you purchase a handbrake with a round end as opposed to a squareish end, it will still fit however, the hole in your boot is larger than our e-brake takes up. You will be required to fold over the bottom part of the e-brake boot as you install it. This can be done at the bottom so it is not visible when it is installed.

NOTE: You will be required to remove your original e-brake handle in order to install these replacements. Your original handle should slide right off once you remove the zip tie holding it in place. If you find it difficult to remove, you may need to run some lubricant (such as WD-40) down the shaft to loosen the handle. If it is still difficult to remove wiggle it back and forth as you pull up. Remember that the handle will come of this way, there is nothing else holding it on, it just may take some strength and patience.